Blue Ridge Machine and Motorsports, LLC

1042 South High Street
Harrisonburg, VA 22801
ph: 540-432-6560
fax: 540-432-6561

Products and Custom made items.

Here at BRMM we are a dealer for more than 300 Manufactures and over 100.000 parts and accessories.

Check out BRMM for all of your Street Performance, Drag Racing, Circle Track, Pulling, Diesel or just need stock replacement parts, We will take the time to hunt it down.

  • Custom made Products.

    401-456 Ford or New Holland Roller Rockers any ratio

    You need custom made parts we can handle it.  Let our Machine and Fab shop handle it for you.

    How about Billet Roller Rockers for your puller.

    This set is for a New Holland Genesis 456 or 456T engine, No more stock broken rockers!

    Fits: 401 Genesis, 456 Genesis, 474 Ford truck head.

    We also use Smith Brothers custom push rods to make this a bullet proof setup.   These rockers have been put to the test this season with no failures.

    This set was done for a local guy that was tired of not making a full run with out breaking the stock stuff!,  plus we can add more ratio to the rockers to give the motor more Duration and Lift to the reground camshafts that most guy's are using, this means MORE AREA UNDER THE CURVE and MORE BOOST!!

  • Custom made deck plates for bigger bores or longer strokes or just bigger cubes!Main gurdle support

    Custom Deck plate and main girdle for the New Holland Genesis 401-456, for the guys with big cubes or high boost.

  • Diesel Puller heads, all types IH, NEW HOLLAND Genesis, CASE, JOHN DEER, MOLINE

    Ported 456 NEW HOLLAND puller headIntake ports on a 456 New Holland puller456 New Holand with roller rockers

    Ported 456" NEW HOLLAND Genesis head for tractor pulling. We spent alot of time on the Superflow 600 bench to get as much air in and out to get this head in race forum.  Installing new roller rockers on the 456 New Holland Genesis.

  • KOHLER and BRIGGS  Single Cylinders.

    K341 Kohler, bored and honed, fully ported, tractor puller. K341 Kohler, bored and honed on the Sunnen CV616 power hone. K341 Kohler being mounted on the flowbench, These are tricky to do.K341 Kohler, Being balanced in the Pro-Bal equipment. NO SHAKES! Custom BRMM / JE Piston, rings and Billet Alu. rod that we have made to specs
    K341 Kohler ported.      K341 bored and honed  K341 Kohler on flowbench  Kohler stroker crank Balanced  Custom rod and piston

    We are also doing the V-twins, we have had alot of experince with head porting for pulling and oval track racing, we can also dyno these engines on our Superflow 901.    

Copyright BRMM, LLC. All rights reserved.

Web Hosting by Yahoo!

1042 South High Street
Harrisonburg, VA 22801
ph: 540-432-6560
fax: 540-432-6561